|
07/11/2016, 06:57 AM | #1 |
Registered Member
Join Date: Feb 2003
Location: Wausau, WI
Posts: 704
|
Reset 6105 to factor
Is it necessary to reset the 6205 to factory after adjusting to run the 7095 multicontroller? I would rather run the pumps on the included controller instead.
Thanks |
07/11/2016, 09:08 AM | #2 |
RC Sponsor
Join Date: Apr 2000
Location: Austin Texas USA
Posts: 35,785
|
I don't understand the question. The 6205 is too old to have a built in controller. If you have a newer pump with a 7090 you just disconnect the 7095 and use the 7090 and it will work correctly.
__________________
Roger Vitko Tunze USA "He's for every one of us, stands for every one of us, he'll save every man, woman and child in a mighty Flash!" Current Tank Info: 210 gallon planted tank with Altum Angelfish |
07/11/2016, 12:07 PM | #3 |
Registered Member
Join Date: Feb 2003
Location: Wausau, WI
Posts: 704
|
Sorry, it was a typo. 6105 with controller. I had adjusted it to work with the 7095 which did not meet my needs so I wanted to go back to the original controller supplied with the pump and wanted to make sure I did not need to change anything back.
Thanks. |
07/11/2016, 12:21 PM | #4 |
RC Sponsor
Join Date: Apr 2000
Location: Austin Texas USA
Posts: 35,785
|
If you just disconnect the 7095 and change it to a mode besides External it should work as it did.
__________________
Roger Vitko Tunze USA "He's for every one of us, stands for every one of us, he'll save every man, woman and child in a mighty Flash!" Current Tank Info: 210 gallon planted tank with Altum Angelfish |
Thread Tools | |
|
|