|
03/08/2014, 07:28 AM | #1 |
Registered Member
Join Date: Apr 2013
Location: Wappingers Falls
Posts: 324
|
Programming code needed for Lights.
Hello Guys I needed programming code for my new lights.
Metal Halide 1 needs to be on for 4 hrs Metal halide 2 needs to be on for 4 hrs but 15 minutes after 1 Set of t5s on for 4 hrs then off for 4 hrs then on for 4 hrs then off till next day. Basically I dont want t5s on when Metal halides are on. But the t5s should go off after both the halides are on. Thanks Guys
__________________
Elos 120, ATI Led Powermodule , Hopefully SPS dominated reef |
03/08/2014, 02:48 PM | #2 |
In Memoriam
Join Date: Nov 2011
Location: Infinity and Beyond
Posts: 2,445
|
I am going to assume you want to start with the t5's for 4 hours then off run the metal halide for 4 hours then the t5's come back on for 4 hours??? You can adjust the times to fit. We will use 8 am as start time.
(T5) Fallback OFF Set OFF If Time 08:00 To 12:00 Then ON If Time 16:15 To 20:15 Then ON (Mh1) Fallback OFF Set OFF If Time 12:00 To 16:00 Then ON (Mh2) Fallback OFF Set OFF If Time 12:15 To 16:15 Then ON Hope that helps. Mark |
03/08/2014, 09:12 PM | #3 |
Registered Member
Join Date: Apr 2013
Location: Wappingers Falls
Posts: 324
|
Thanks bud you are the best.
__________________
Elos 120, ATI Led Powermodule , Hopefully SPS dominated reef |
10/16/2017, 06:41 PM | #4 |
Registered Member
Join Date: Dec 2009
Location: Jacksonville, Fl
Posts: 92
|
Three years later and it's helped me too. Thanks Mark.
__________________
Merc |
Thread Tools | |
|
|