|
|
|
03/30/2012, 08:13 PM
|
#1 |
|
Registered Member
Join Date: May 2005
Location: San Francisco Bay, Pacifica CA
Posts: 867
|
Tunze 6100.10 and 7240.27 not changing speeds
As the title says, I just got this set, unused, but I can't get it to change speed using an APEX. I know this is the Tunze page, but I checked my APEX and it's putting out the correct voltage.
If I turn the Max power knob the pump slows down and speeds up correctly, but once it's plugged into my APEX it just stays on whatever setting I have the knob at. Any idea's would be great. Thanks in advance
__________________
__________________________________________________________________ Michael "No honey it's not a new coral, I just moved it to a new spot" "No honey it's not a new tank, I ah.... Just moved it to a new spot" Current Tank Info: 180g mixed reef, 60 Frag/shallow reef, 50g seahorse dedicated, 20g reef, and finally a 29g cube for the office |
|
|
|
04/01/2012, 09:19 PM
|
#2 |
|
Registered Member
Join Date: May 2005
Location: San Francisco Bay, Pacifica CA
Posts: 867
|
Please close. It's just not working off the apex correctly. Working off tunze controller just fine.
__________________
__________________________________________________________________ Michael "No honey it's not a new coral, I just moved it to a new spot" "No honey it's not a new tank, I ah.... Just moved it to a new spot" Current Tank Info: 180g mixed reef, 60 Frag/shallow reef, 50g seahorse dedicated, 20g reef, and finally a 29g cube for the office |
|
|
|
 |
|
|
