|
11/19/2017, 04:43 PM | #1 |
Registered Member
Join Date: Aug 2006
Location: IE
Posts: 1,422
|
Did I Fry my VS Ports? DIY LED/VSPort Problem
I've been working on a RapidLED build for a few weeks now.
I've progressed to the point of connecting the LEDS to Apex. VS3&4. I'm having trouble finding which wires are activated. There are of course 4 sets of wires in the cable. One set reads 10v another wont read steady and keeps changing; two others read 0 v. I've tried toggling the LEDS on and off in Fusion but nothing. I moved the ethernet cable to VS1&2 but no hel p - still the same readings. Also - when I plugged my Return Pump back into VS1/2 port - it is now not controllable any longer, it just runs at 100%. So now the LEDS are not working and my return is no longer controllable - any advice? Did I fry my ports somehow?
__________________
"In a free government the security for civil rights must be the same as that for religious rights." -James Madison Current Tank Info: 120 Visio // Radions // Eschopps Skimmer // MP40 x2 // Tunze ATO // BRS Dosing Pumps and Dual Reactor // Apex Gold // |
12/05/2017, 08:11 PM | #2 |
Registered Member
Join Date: Jun 2010
Location: Tampa
Posts: 643
|
Did you check to make sure what Profile was set the VS port? Is it possible you changed it to something else to test? If the profile is correct, then Yes It sounds like it's toast.
__________________
Matt Don't pee on my leg and tell me it's raining. Current Tank Info: 190 |
Thread Tools | |
|
|