|
12/02/2017, 07:34 PM | #1 |
Registered Member
Join Date: Dec 2017
Posts: 5
|
custom sump for reefer 170 sketch
Hi,
I am looking to build custom sump for my reefer 170. I would like to use it for the Triton method. Let me know what you guys think about it. PS. What software you guys use to design sumps? Attachment 383664 Attachment 383665 Attachment 383666 Attachment 383668 Attachment 383669 |
12/02/2017, 09:28 PM | #3 |
Registered Member
Join Date: Feb 2011
Location: Cypress, Texas
Posts: 1,904
|
Why have that wing after the skimmer? And why have teeth there? It will just make more noise and spray than a flat weir would (and a flat one shouldn't need the wing).
I had the layout backwards... Uh, you will get some ugly water into the refuge running it all through there first. Return may be a little small also, depending on pump height and water level. You may end up with only about 1 gallon of range before its sucking air... Last edited by Gorgok; 12/02/2017 at 09:33 PM. |
12/02/2017, 10:48 PM | #4 |
Registered Member
Join Date: Dec 2017
Posts: 5
|
I was looking in to the triton guides and most of them are suggesting fuge before the skimmer. The wing is just to stop the chaeto form going over. I did up the return to 5x10 and it will be 9 high. I will remove the teeth. My space is really limited. For return i was thinking about VECTRA S1.
sump8.jpg How about this one? |
|
|