|
02/25/2019, 08:37 PM | #1 |
Registered Member
Join Date: Jan 2004
Location: Ont. Canada
Posts: 2,308
|
AI Prime for a frag tank
Hi All,
Just set up a small frag tank. 24" X 20" X 12". Would one AI Prime be enough for a mainly SPS tank? If not, any suggestions? Thanks in advance.
__________________
Blessed are the poor in spirit for theirs is the kingdom of heaven.. Current Tank Info: 180 Gallon, 3 G4 Radions |
03/01/2019, 06:11 PM | #2 |
Registered Member
Join Date: Jan 2004
Location: Ont. Canada
Posts: 2,308
|
If this was a 300 gallon needing an opinion on lighting there would be 300 ppl chiming in lol!
__________________
Blessed are the poor in spirit for theirs is the kingdom of heaven.. Current Tank Info: 180 Gallon, 3 G4 Radions |
03/01/2019, 06:39 PM | #3 |
Registered Member
Join Date: Nov 2007
Location: San Gabriel, California
Posts: 681
|
Yes it will. Center of the light will have the most PAR and will follow the published illumination map outward
|
03/01/2019, 10:54 PM | #4 |
Registered Member
Join Date: Jan 2004
Location: Ont. Canada
Posts: 2,308
|
Hey finally, thanks. I k ow the par is lower than desired. As long as it can keep them alive for a short time I can work with it.
__________________
Blessed are the poor in spirit for theirs is the kingdom of heaven.. Current Tank Info: 180 Gallon, 3 G4 Radions |
03/02/2019, 06:35 PM | #5 |
Registered Member
Join Date: Nov 2007
Location: San Gabriel, California
Posts: 681
|
Keep the frags centered under the light and higher up than lower. This will maximize par. But keep in mind that they will also put out more par than you think so you need to be cautious with where you place them. Start them lower and off to the side then work them up closer to where your par levels will be under your DT lights.
|
03/02/2019, 09:50 PM | #6 |
Registered Member
Join Date: Jun 2013
Posts: 1,083
|
Not sure it will, tbh. I have a 24x24 cube and I have 8 t5s over it.
Sent from my LM-Q710.FG using Tapatalk |
|
|