Reef Central Online Community

Go Back   Reef Central Online Community > Blogs > mr9iron
Blogs FAQ Calendar Mark Forums Read

Notices

Rate this Entry

Bean Animal goof need help

Posted 05/20/2019 at 11:35 AM by mr9iron

Quote:
Originally Posted by mr9iron View Post
I purchased a Modular Marine 1200 gph overflow that has 3/4 uniseals on the external box to go to the sump.

I ran 3/4 pipe from the box about 8 inches down then coupled it to 1 inch plumbing and immediately installed the gate valve. The gate valve sits about 2 feet above the sump.

The weir is connected via 1 inch bulkheads that go to the external box and flow through the above mentioned pipe.

I cannot get enough flow through the weir to balance the Bean Animal.

I am using a Vectra L1 pump on a 93 gallon cube and it is returned via 1 inch plumbing with a couple of tees, 90s and a manifold.

Should I:
1. Install the gate valve at the sump so that the 1 inch pipe fills up and I can better adjust it. As it is now because of the increase of pipe size and the height of my gate valve I donít think the 1 inch pipe is able to get a full siphon going.

Or:
2. Rip out all of my plumbing and go 3/4.




Sent from my iPhone using Tapatalk
Posted in Uncategorized
Views 41161 Comments 1 Edit Tags Email Blog Entry
« Prev     Main     Next »
Total Comments 1

Comments

  1. New Comment
    Id rip it all out and do it again, but that's cause I am OCD.
    Posted 01/09/2020 at 01:30 PM by kiMxD kiMxD is offline
 

All times are GMT -6. The time now is 10:09 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Powered by Searchlight © 2022 Axivo Inc.
Use of this web site is subject to the terms and conditions described in the user agreement.
Reef CentralTM Reef Central, LLC. Copyright ©1999-2022
User Alert System provided by Advanced User Tagging v3.3.0 (Pro) - vBulletin Mods & Addons Copyright © 2022 DragonByte Technologies Ltd.