View Single Post
Unread 02/14/2010, 10:10 PM   #3
customcolor
Registered Member
 
customcolor's Avatar
 
Join Date: Dec 2006
Location: kaukauna, wi.
Posts: 3,879
mounting the leds i used 10-24 stainless screws. i made shure that every one was away from the solder on the leds...i dont want a short happening!!! i even used a multi meter to make shure there wasnt!!! i didnt have any nylon washers to use but i would advise them so you dont have to worry...ill be upgrading these soon..but this set up does work..



i went to radio shack for some of this stuff since i didnt want to make the leds a permanent thing...just incase i wanna change the set up or put it in another set up



just a dab will do ya!!



half the lights (blues)



and the other half(whites)






to be continued..........


__________________
PLEASE DONT USE GREAT STUFF (THE YELLOW STUFF) IN YOUR TANK........USE POND FOAM (THE BLACK STUFF).. I BEG YOU!

Great stuff====$5 a can
24-48 hour cure
Epoxy to cover it====little as $5 for small projects or up to $100+ for larger projects
and another 24-48 hour cure
I hope you covered it well cuz if you didnt it will start to break down in a few months
sand is another added cost to cover up the yellow.

Pond foams====$9-$15 a can
24-48 hour cure
DONE! You can cover it with sand if you want to (YOU DONT HAVE TO) though but thats added cost again

Current Tank Info: 75 gal under way
customcolor is offline   Reply With Quote