Quote:
Originally posted by spleify
leebo_28, I decided on the size. Set the 1/4" straight router bit to appropriate height. Made the cuts. Set the table saw to appropriate width, and just a little high. Made the cut, flipped it over made second cut. DONE!! woohoo $1 corner trim, and I didn't even have to leave the house.
HTH
Spleify
|
Thanks for sharing this with me...I just finished painting a basement for a relative, and they couldn't afford fancy baseboard.I think if I thicken those corners up a bit they would resemble cove trim ,and dress up the 1x4's they put in for base(cheaply).
thanks again..lee