View Single Post
Unread 11/24/2007, 11:33 AM   #8
thrillreefer
Registered Member
 
thrillreefer's Avatar
 
Join Date: Dec 2005
Location: Newton, MA
Posts: 308
Because the overflow box is so tiny, I can't take the bulkhead out (at least without cutting off most of the threads). I will probably have to cut the threads to fit the tee for the durso behind the tank, but I need to leave enough to cement in a bit of 1" PVC to attach the tee. So I came up with another solution. I cut a 1" PVC male adapter, removed some of the threads and cut some acrylic scraps to build a makeshift elbow.


I used gel superglue to attach everything, and the DIY fitting was strong enough to hold up to sanding and shaping with a file. I leak tested it, and here it is ready to screw into the overflow:


Screwing the thing in will be fairly difficult, since I have so little room to maneuver and can't get more than a finger or two inside the box. I bought PVC and fittings, so I should be able to make the rest of the durso once I get this guy in.


thrillreefer is offline   Reply With Quote