|
|
|
02/08/2011, 03:01 PM
|
#1 |
|
Registered Member
Join Date: Feb 2007
Location: CT
Posts: 66
|
Led Driver question
Hello I am wiring up my drivers and was wondering if I can hook two drivers up to one plug or is it best to put a plug on each one.
Thanks Steve |
|
|
|
02/08/2011, 04:06 PM
|
#2 |
|
Registered Member
Join Date: Dec 2008
Location: Chicago IL
Posts: 245
|
are you talking about the edison plug for AC power in? I would consider it good practice to just wire separate plugs on them, but you could do it yes it is physically possible
__________________
Will Kent Lighting Designer [IMG]http://www.rowe lab.com/AquaController/sig.php?n=kentlighting[/IMG] Current Tank Info: 90 Gallon reef |
|
|
|
|
02/08/2011, 05:32 PM
|
#3 |
|
Registered Member
Join Date: Jun 2006
Location: Tulsa, OK
Posts: 1,295
|
Yes, you can. I wired 2 Meanwell's to the same plug. You just have less control over turning them on/off individually.
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question on LED driver from PWM output circuit | snorkeler | Do It Yourself |
30 | 06/26/2011 08:05 PM |
| LED driver questions | hvacman250 | Do It Yourself |
29 | 01/27/2011 09:41 AM |
| Should I use LED Drivers or Resistors? | titancrusher1 | Do It Yourself |
20 | 12/03/2010 07:06 AM |
| LED driver question | manycolors | Do It Yourself |
7 | 08/16/2010 07:39 PM |
| CREE XLED & LED Drivers Questions??? | DeathWish302 | Do It Yourself |
19 | 09/24/2008 11:01 AM |
