|
06/22/2007, 09:15 AM | #1 |
Moved On
Join Date: Apr 2007
Location: Charlotte, NC, USA
Posts: 3,412
|
Questions for an owner of a Tunze Nano DOC 9002 skimmer
I'm trying to determine if the Nano DOC 9002 would fit in the rear filtration compartment of my 34 gallon Red Sea Max tank:
1) I need to know the width (diameter) of the skimmer cup? 2) What is the height of the skimmer cup - not including the tube underneath - just the height of the exposed part that would be sitting on top of the main unit after sliding it in place. 3) I can't tell from the online manual that I looked at - how does the unit actually attach to the hanging rack does it slide onto the rack or ? 4) Is the vertical position of the skimmer on the hanging rack adjustable up & down, to account for the actual water level? Thanks |
09/28/2007, 04:04 AM | #2 |
Registered Member
Join Date: Dec 2006
Location: other
Posts: 4
|
Any updates to this? Apologies for bumping an old thread.
|
09/28/2007, 04:24 AM | #3 |
Premium Member
Join Date: Dec 2006
Location: New York
Posts: 513
|
try posting this on the "Tunze" forum under the Vendor Forum section of reefcentral.
The few times I had questions on tunze products, I usually got an answer within a few hours from a service rep. |
09/29/2007, 12:43 AM | #4 |
Registered Member
Join Date: Nov 2005
Location: Denmark
Posts: 171
|
The cup is 95 mm (3 3/4 inches) in diameter at the top and just about 100 mm (4 in) high above the body of the skimmer.
I can't tell you anything about the bracket mount as my 9002 came as part of the reefpack so I have the magnet mount. |
|
|