|
|
|
04/15/2010, 05:56 AM
|
#1 |
|
Registered Member
Join Date: Dec 2009
Location: manchester, tn
Posts: 1,139
|
BTA/Clown tank build
Well I am going to take Rhett's advice and take my time planning and getting advice instead of just jumpin in and winging it on this one. So here goes.
I am wanting to build a species tank for BTA/clowns. I want it to be totally self contained and I want to be able to connect it to SPS frag tanks on each side. I am thinking 24x30x16. I would also like to be able to topview if I get brave with the acrylic work. I plan on having a wavemaker / filtration insert. I am open to any and all comments and suggestions. A few specific questions 1. dimensions? the back 6" will be used for the insert. 2. lighting suggestions. LED, MH, T-5, other 3. algae scrubber and or chaeto for filtration well that is enough for starts thanks in advance for the advice. -bart
__________________
185 gal SPS "The Pheonix", 300 gal SPS Dominant "Remember the signs" - C.S. Lewis The Silver Chair |
|
|
|
04/15/2010, 09:40 AM
|
#2 |
|
Got tubes?
Join Date: Dec 2006
Location: Nashville, TN
Posts: 6,759
|
What are you planning on using for filtration?
It may be difficult to find a really good hang-on skimmer that could handle the load and provide pristine water for your SPS.  As far as lighting goes, I think that would be up to you. Personally I'm going with DIY LEDs with my new office tank to keep heat down. I would put some more thought into the filtration if you're also wanting to do SPS tanks. I think algae scrubbers are intriguing, but I also think they're more supplemental than anything. Maybe not, though. Brandon
__________________
I am proof that post count is not directly proportional to "reef IQ". Zip Ties = Reef Duck Tape Geek it till it MHz!!! Current Tank Info: 180g Build in Process |
|
|
|
|
04/15/2010, 03:50 PM
|
#3 |
|
Registered Member
Join Date: Dec 2009
Location: manchester, tn
Posts: 1,139
|
i was thinking a diy needlewheel
__________________
185 gal SPS "The Pheonix", 300 gal SPS Dominant "Remember the signs" - C.S. Lewis The Silver Chair |
|
|
|
|
04/15/2010, 03:54 PM
|
#4 |
|
Got tubes?
Join Date: Dec 2006
Location: Nashville, TN
Posts: 6,759
|
Gotcha. Were you planning on making one that would fit in the back section?
Brandon
__________________
I am proof that post count is not directly proportional to "reef IQ". Zip Ties = Reef Duck Tape Geek it till it MHz!!! Current Tank Info: 180g Build in Process |
|
|
|
|
04/15/2010, 04:42 PM
|
#5 |
|
Registered Member
Join Date: Dec 2009
Location: manchester, tn
Posts: 1,139
|
yes it would be in the back and feed into the RDSB section. i am thinking about 6x8"square and a recirculator with a slow bleed in. i think i attached a sketch. BTW what is the best application for drawings to upload ppt?
__________________
185 gal SPS "The Pheonix", 300 gal SPS Dominant "Remember the signs" - C.S. Lewis The Silver Chair |
|
|
|
 |
| Tags |
| bta; clown fish, tank build |
|
|
